http://www.tech21nyc.com/support/manuals/sansamp/BassDriver-OM2.pdf
WITH BASS AMP RIG:
•As a Stomp Box: Run the 1/4 Output into the front input of an amp. For best results, keep
SansAmp Bass Driver DI s Level close to unity gain so as not to overload the amp s input, which
could yield undesirable distortion.
•As a Pre-Amp: Run the 1/4 Output of SansAmp Bass Driver DI directly into the power amp input,
a.k.a. effects return (if applicable), of an amp.This will bypass the tone-coloring pre-amp section of
the amp rig.
TO DRIVE A POWER AMP: Run the 1/4 Output, or the XLR Output to the corresponding
input of a power amp, and adjust your stage volume with the Level control of SansAmp Bass Driver DI.
NOTE: When running into the power amp input of an amp or a power amp alone, make sure the
Output Level Switch is set to Line and adjust the Level as needed. If you are so inclined, this is the time to
crank it!
TO RECORD DIRECT: Plug the XLR or 1/4 Output directly into the input of a mixer/recorder.
Work with the input trim control on the mixer/ recorder and be sure not to overload its input. If the
Level is below 12 o clock and it is overloading the board, set the Output Level switch to Instrument.
Additionally, bear in mind that full-range systems yield a wide frequency response.Therefore, we suggest you start with the EQ levels at 12 o clock and then increase/decrease to taste.
